StudyFox
कीमतेंब्लॉगएक्सटेंशनमुफ़्त टूल
  • कीमतें
  • ब्लॉग
  • एक्सटेंशन
  • मुफ़्त टूल
  • शुरू करेंसाइन इन
StudyFox

अपने नोट्स, PDF और स्लाइड्स को फ़्लैशकार्ड, क्विज़, नोट्स और माइंड मैप में बदलें।

StudyFox खोलें

स्टडी टूल्स

  • होमवर्क हेल्पर
  • नोट मेकर
  • फ़्लैशकार्ड मेकर
  • क्विज़ मेकर
  • माइंड मैप मेकर

प्रोडक्ट

  • कीमतें
  • Chrome एक्सटेंशन
  • मुफ़्त एक्सटेंशन
  • स्टडी सेट देखें
  • ब्लॉग

सहायता

  • सहायता केंद्र
  • संपर्क करें
  • गोपनीयता नीति
  • सेवा की शर्तें

तुलना करें

  • Chegg का विकल्प
  • Course Hero का विकल्प
  • Coursology का विकल्प
  • Photomath का विकल्प
  • Gauthmath का विकल्प
  • PhotoSolve का विकल्प
  • CollegeTools का विकल्प
  • Transcript का विकल्प
  • SmartSolve का विकल्प
  • Homeworkify का विकल्प
  • AnswersAi का विकल्प
  • StudyX का विकल्प
  • Quizlet का विकल्प
  • Anki का विकल्प
  • Knowt का विकल्प
  • Brainscape का विकल्प
  • सभी तुलनाएँ

© 2026 StudyFox AI. सर्वाधिकार सुरक्षित।

  • X
  • Discord
  • Instagram
ExploreEngineering & TechChemical EngineeringHeat Transfer Fundamentals Quiz: Conduction, Convection, Radiation and Exchangers

Quiz · Medium

Heat Transfer Fundamentals Quiz: Conduction, Convection, Radiation and Exchangers

Conceptual questions on resistances, dimensionless groups, radiation and exchanger behavior.

by Kill h.21 questionsCreated Nov 20, 2026, 08:27 PM
Chemical Engineering· Heat TransferTags#heattransfer#concepts

21 questions

  1. 1

    Compared with parallel flow, a counterflow exchanger with the same terminal temperatures has:

    • A

      A smaller LMTD

    • A larger LMTD, so a smaller area

    • C

      The same LMTD

    • D

      A lower effectiveness

    Counterflow keeps a more uniform ΔT along the exchanger, giving a larger LMTD, less area and higher effectiveness for the same NTU.

  2. 2

    Which statement about steady conduction through layers in series is correct?

    • A

      Each layer has the same temperature drop

    • Each layer carries the same heat rate

    • C

      The layer with the highest k has the largest temperature drop

    • D

      Resistances are added as reciprocals

    In steady state the same q passes through every layer. The drop in each layer is q R, so the layer with the largest resistance (lowest k for equal thickness) drops most. Resistances in series simply add; reciprocals are for parallel paths.

  3. 3

    In the wall shown, which layer has the lowest thermal conductivity (equal thicknesses)?

    • B

    • B

      A

    • C

      C

    • D

      They are all equal

    Same flux, so the layer with the steepest temperature gradient has the smallest k. Layer B has the steepest slope.

  4. 4

    The Biot number is the ratio of:

    • A

      Convection resistance to conduction resistance inside the solid

    • B

      Momentum to thermal diffusivity

    • C

      Buoyancy to viscous forces

    • Conduction resistance inside the solid to convection resistance at the surface

    Bi = hL/k_s = (L/k_s)/(1/h). A small Bi means the solid is nearly uniform in temperature. Option 3 is Gr and 4 is Pr.

  5. 5

    A thin copper plate is quenched in water. Which assumption is most likely valid?

    • A

      Steady state

    • B

      Radiation dominates

    • C

      Semi-infinite solid

    • Lumped capacitance

    Copper has a very high k and the plate is thin, so Bi is very small and the temperature is uniform inside.

  6. 6

    For a cylindrical pipe with outer radius smaller than k/h, adding insulation:

    • Increases heat loss until the critical radius is reached

    • B

      Raises the surface temperature to infinity

    • C

      Always lowers heat loss

    • D

      Has no effect

    Below the critical radius r_c = k/h, the outer convective resistance falls faster than the insulation resistance rises, so heat loss rises to a maximum at r_c and only then decreases.

  7. 7

    Which dimensionless number is the heat-transfer analog of the Schmidt number?

    • A

      Stanton

    • Prandtl

    • C

      Grashof

    • D

      Nusselt

    Pr = ν/α compares momentum and thermal diffusivities, just as Sc = ν/D does for mass. Nusselt is the analog of Sherwood.

  8. 8

    Dittus-Boelter (Nu = 0.023 Re^0.8 Pr^n) uses n = 0.4 when the fluid is:

    • Heated

    • B

      Cooled

    • C

      In laminar flow

    • D

      In natural convection

    n = 0.4 for heating the fluid and 0.3 for cooling it. The correlation applies only to turbulent flow.

  9. 9

    In fully developed laminar flow in a tube with constant wall temperature, Nu is approximately:

    • 3.66, independent of Re

    • B

      2

    • C

      4.36 and rises with Re

    • D

      0.023 Re^0.8

    Nu = 3.66 for constant wall temperature, 4.36 for constant heat flux; both independent of Re and Pr.

  10. 10

    Radiative emissive power of a blackbody is proportional to:

    • A

      T^2

    • B

      T^3

    • T^4

    • D

      T

    E_b = σT^4 with T in kelvin.

  11. 11

    Wien's displacement law says that as temperature increases, the peak emission wavelength:

    • A

      Becomes infinite

    • B

      Increases

    • C

      Stays constant

    • Decreases

    λ_max T = 2898 μm·K, so a hotter body peaks at shorter wavelengths.

  12. 12

    In which exchanger can the cold fluid leave hotter than the hot fluid leaves?

    • A

      Neither

    • B

      Parallel flow only

    • C

      Both

    • Counterflow only

    In counterflow the cold outlet meets the hot inlet, so it can exceed the hot outlet temperature. In parallel flow both streams approach a common temperature.

  13. 13

    When one fluid condenses at constant temperature (C_r = 0), the effectiveness is:

    • A

      Always 1

    • B

      NTU/(1+NTU)

    • 1 - exp(-NTU)

    • D

      (1 - e^-NTU)/2

    C_r = 0 collapses every arrangement to ε = 1 - e^(-NTU).

  14. 14

    Which is the best location for fins on a gas-to-liquid exchanger?

    • A

      Neither: fins never help

    • B

      Both sides equally

    • The gas side

    • D

      The liquid side

    Fins add area to the side with the smaller h (gas), where the resistance is largest. Adding area to the liquid side hardly changes U.

  15. 15

    The critical heat flux in pool boiling marks:

    • The maximum heat flux for nucleate boiling, beyond which film forms

    • B

      The start of nucleate boiling

    • C

      The condensation limit

    • D

      The minimum film-boiling flux

    Past CHF, vapor blankets the surface and temperature jumps, which can burn out the heater. The Leidenfrost point is the minimum flux for film boiling.

  16. 16

    Which condensation mode gives much higher heat-transfer coefficients?

    • A

      Neither can condense

    • B

      Filmwise

    • Dropwise

    • D

      Both are equal

    In dropwise condensation, drops expose bare surface, so h can be about 5 to 10 times higher than in filmwise condensation, but it is hard to maintain.

  17. 17

    True or False: The convective heat transfer coefficient h is a property of the fluid only.

    • A

      True

    • False

    h depends on the fluid properties and also on velocity, geometry, surface condition and flow regime.

  18. 18

    In a shell-and-tube exchanger, the highly fouling fluid is normally placed:

    • In the tubes

    • B

      Either side without consequences

    • C

      On the shell side

    • D

      In the baffles

    Tube-side fluid is easier to clean (open the heads and clean tubes mechanically) and velocities are easier to keep high.

  19. 19

    The overall U in 1/U = 1/h_i + R_f + 1/h_o is dominated by:

    • A

      The wall conductivity always

    • B

      The average of h_i and h_o

    • The smallest h or largest resistance

    • D

      The largest h

    Resistances add, so the largest resistance (smallest h) controls U. Improving the fluid with already-high h barely changes U.

  20. 20

    Natural convection becomes important compared with forced convection when:

    • A

      Bi is small

    • B

      Re is very large

    • Gr/Re² is about 1 or larger

    • D

      Pr is 1

    Gr/Re² measures buoyancy versus inertia. Near 1 both contribute; much larger than 1, natural convection dominates.

  21. 21

    A radiation shield with the same emissivity is placed between two large parallel plates. The net radiative exchange becomes:

    • A

      The same

    • B

      Zero

    • About half

    • D

      Doubled

    One shield doubles the radiative resistance (two gaps in series), halving the exchange.