StudyFox
कीमतेंब्लॉगएक्सटेंशनमुफ़्त टूल
  • कीमतें
  • ब्लॉग
  • एक्सटेंशन
  • मुफ़्त टूल
  • शुरू करेंसाइन इन
StudyFox

अपने नोट्स, PDF और स्लाइड्स को फ़्लैशकार्ड, क्विज़, नोट्स और माइंड मैप में बदलें।

StudyFox खोलें

स्टडी टूल्स

  • होमवर्क हेल्पर
  • नोट मेकर
  • फ़्लैशकार्ड मेकर
  • क्विज़ मेकर
  • माइंड मैप मेकर

प्रोडक्ट

  • कीमतें
  • Chrome एक्सटेंशन
  • मुफ़्त एक्सटेंशन
  • स्टडी सेट देखें
  • ब्लॉग

सहायता

  • सहायता केंद्र
  • संपर्क करें
  • गोपनीयता नीति
  • सेवा की शर्तें

तुलना करें

  • Chegg का विकल्प
  • Course Hero का विकल्प
  • Coursology का विकल्प
  • Photomath का विकल्प
  • Gauthmath का विकल्प
  • PhotoSolve का विकल्प
  • CollegeTools का विकल्प
  • Transcript का विकल्प
  • SmartSolve का विकल्प
  • Homeworkify का विकल्प
  • AnswersAi का विकल्प
  • StudyX का विकल्प
  • Quizlet का विकल्प
  • Anki का विकल्प
  • Knowt का विकल्प
  • Brainscape का विकल्प
  • सभी तुलनाएँ

© 2026 StudyFox AI. सर्वाधिकार सुरक्षित।

  • X
  • Discord
  • Instagram
ExploreEngineering & TechElectrical EngineeringCircuits Exam Practice: Transients, Resonance and Equivalents

Quiz · Hard

Circuits Exam Practice: Transients, Resonance and Equivalents

Multi-step problems on RLC damping, first-order transients, complex power, Q factor and AC maximum power transfer.

by Kill h.15 questionsCreated Nov 20, 2026, 08:27 PM
Electrical Engineering· CircuitsTags#circuits#transients#resonance

15 questions

  1. 1

    Series RLC: , H, F. What is the damped natural frequency?

    • A

      About 316 rad/s

    • About 245 rad/s

    • C

      About 200 rad/s

    • D

      About 116 rad/s

    , , rad/s. 316 is the undamped frequency.

  2. 2

    A 5 V step is applied to R = 1 kΩ in series with C = 1 μF (initially uncharged). The capacitor voltage at t = 1 ms is

    • A

      about 5 V

    • B

      about 1.84 V

    • about 3.16 V

    • D

      about 2.5 V

    ms, so V. 1.84 V is the resistor voltage .

  3. 3

    An RL circuit (R = 10 Ω, L = 50 mH) is connected to 20 V at t = 0. What is the current at t = 5 ms?

    • A

      About 2 A

    • B

      About 0.74 A

    • C

      About 1.0 A

    • About 1.26 A

    ms, A, A. 0.74 A is the unreached remainder.

  4. 4

    A capacitor starts at 2 V, is switched to a 10 V source, and the circuit has ms. Its voltage at t = 2 ms?

    • About 7.06 V

    • B

      About 8.74 V

    • C

      About 5.0 V

    • D

      About 6.32 V

    V. 6.32 V would apply only if starting from 0 V and heading to 10 V.

  5. 5

    A Thevenin source (9 V, 3 Ω) drives a 6 Ω load. The load voltage is

    • A

      9 V

    • 6 V

    • C

      4.5 V

    • D

      3 V

    Divider: V (current 1 A). 4.5 V would be a matched 3 Ω load.

  6. 6

    Why is a dependent source NOT turned off when finding R_th?

    • A

      Because dependent sources have zero internal resistance

    • B

      Because turning it off would short the load

    • Because its value is set by a circuit variable, so removing it changes the network's behavior; use a test source instead

    • D

      Because dependent sources are always current sources

    A dependent source depends on voltages or currents in the circuit, so it must remain. Apply a test voltage or current at the terminals to find R_th = V_test / I_test.

  7. 7

    A 10 Ω resistor is in parallel with a capacitor of reactance 10 Ω. The impedance is

    • A

    • B

    • C

    , magnitude 7.07 Ω at -45°. Series addition (10 - j10) is the usual trap.

  8. 8

    A load has V rms and A rms. The reactive power Q is

    • 300 var (inductive)

    • B

      520 var (inductive)

    • C

      300 var (capacitive)

    • D

      600 var (inductive)

    VA, W, var. Current lags, so inductive. 520 is P.

  9. 9

    A series RLC has , mH. What is its bandwidth?

    • A

      10 rad/s

    • 1000 rad/s

    • C

      100 rad/s

    • D

      10 000 rad/s

    rad/s (159 Hz). It equals .

  10. 10

    Series RLC: , mH, F. The quality factor is

    • A

      about 0.16

    • B

      about 63

    • about 6.3

    • D

      about 3162

    rad/s, . 3162 is the resonant frequency itself.

  11. 11

    A source has . For maximum average power, the load impedance should be

    • A

    • B

    • C

    The load must be the complex conjugate so reactances cancel: . A 5 Ω resistor matches only the magnitude.

  12. 12

    A 24 V source in series with 6 Ω is converted to a Norton source. The result is

    • 4 A in parallel with 6 Ω

    • B

      144 A in parallel with 6 Ω

    • C

      4 A in series with 6 Ω

    • D

      24 A in parallel with 6 Ω

    I = V/R = 4 A with the same 6 ohms in parallel.

  13. 13

    A capacitor discharges through a circuit with tau = 5 ms. How long until it has fallen to 10% of its initial voltage?

    • A

      About 5 ms

    • About 11.5 ms

    • C

      About 25 ms

    • D

      About 2.3 ms

    ms. 2.3 ms drops the tau factor.

  14. 14

    In a circuit three elements absorb 20 W, 15 W and 5 W, and one more element is the only source. By Tellegen's theorem, the power absorbed by the source is

    • A

      +40 W

    • B

      0 W

    • -40 W

    • D

      -20 W

    Absorbed power sums to zero, so the source absorbs -(20+15+5) = -40 W; that is, it delivers 40 W.

  15. 15

    The curve marks the capacitor voltage at one time constant. If V, what is its value there?

    • A

      3.68 V

    • B

      10 V

    • C

      5 V

    • 6.32 V

    V. 3.68 V is what remains below .