StudyFox
कीमतेंब्लॉगएक्सटेंशनमुफ़्त टूल
  • कीमतें
  • ब्लॉग
  • एक्सटेंशन
  • मुफ़्त टूल
  • शुरू करेंसाइन इन
StudyFox

अपने नोट्स, PDF और स्लाइड्स को फ़्लैशकार्ड, क्विज़, नोट्स और माइंड मैप में बदलें।

StudyFox खोलें

स्टडी टूल्स

  • होमवर्क हेल्पर
  • नोट मेकर
  • फ़्लैशकार्ड मेकर
  • क्विज़ मेकर
  • माइंड मैप मेकर

प्रोडक्ट

  • कीमतें
  • Chrome एक्सटेंशन
  • मुफ़्त एक्सटेंशन
  • स्टडी सेट देखें
  • ब्लॉग

सहायता

  • सहायता केंद्र
  • संपर्क करें
  • गोपनीयता नीति
  • सेवा की शर्तें

तुलना करें

  • Chegg का विकल्प
  • Course Hero का विकल्प
  • Coursology का विकल्प
  • Photomath का विकल्प
  • Gauthmath का विकल्प
  • PhotoSolve का विकल्प
  • CollegeTools का विकल्प
  • Transcript का विकल्प
  • SmartSolve का विकल्प
  • Homeworkify का विकल्प
  • AnswersAi का विकल्प
  • StudyX का विकल्प
  • Quizlet का विकल्प
  • Anki का विकल्प
  • Knowt का विकल्प
  • Brainscape का विकल्प
  • सभी तुलनाएँ

© 2026 StudyFox AI. सर्वाधिकार सुरक्षित।

  • X
  • Discord
  • Instagram
ExploreEngineering & TechElectrical EngineeringElectronics Exam Practice: Calculations on Amplifiers, 555 and Power Supplies

Quiz · Hard

Electronics Exam Practice: Calculations on Amplifiers, 555 and Power Supplies

Applied problems on gain-bandwidth, slew rate, 555 timers, rectifier ripple, buck converters and loading effects.

by Kill h.14 questionsCreated Nov 20, 2026, 08:27 PM
Electrical Engineering· ElectronicsTags#electronics#555-timer#power-supplies

14 questions

  1. 1

    An op-amp has a gain-bandwidth product of 2 MHz. In a non-inverting amplifier with gain 40, the -3 dB bandwidth is about

    • A

      2 MHz

    • B

      80 kHz

    • C

      500 kHz

    • 50 kHz

    BW = GBW / gain = 2 MHz / 40 = 50 kHz.

  2. 2

    An op-amp's slew rate is 0.5 V/μs. What is the highest frequency at which an undistorted 10 V peak sine wave can be output?

    • About 7.96 kHz

    • B

      About 50 kHz

    • C

      About 796 kHz

    • D

      About 79.6 kHz

    kHz. Check the unit: 0.5 V/μs = 5×10^5 V/s.

  3. 3

    A 555 timer in astable mode has kΩ, kΩ and μF. The frequency is about

    • A

      1.44 kHz

    • 686 Hz

    • C

      145 Hz

    • D

      6.9 kHz

    Hz.

  4. 4

    For the same 555 circuit ( kΩ, kΩ) what is the duty cycle?

    • A

      About 48%

    • B

      About 91%

    • About 52%

    • D

      50% exactly

    . An astable 555 duty cycle is always above 50%.

  5. 5

    A BJT biased at mA drives a collector load of kΩ ( mV). The mid-band gain of a common-emitter stage (no emitter resistor, ignoring r_o and loading) is about

    • A

      -100

    • B

      -40

    • C

      +400

    • -400

    mS, . The negative sign reflects inversion.

  6. 6

    A zener ( V) regulates from V with a series resistor. Load current is 20 mA and the minimum Zener current should be 5 mA. The largest allowed series resistor is about

    • 276 Ω

    • B

      345 Ω

    • C

      690 Ω

    • D

      138 Ω

    . Using only the load current (20 mA) would give 345 Ω, leaving no Zener current.

  7. 7

    A full-wave bridge rectifier fed by a 12 V peak transformer secondary and loaded by 100 Ω has an output peak of about

    • A

      12 V

    • 10.6 V

    • C

      11.3 V

    • D

      6 V

    Two diodes conduct at a time, dropping about 1.4 V: 12 - 1.4 = 10.6 V. 11.3 V uses only one diode drop.

  8. 8

    A filter capacitor of 1000 μF supplies 100 mA to a full-wave rectified 60 Hz supply. The ripple is about

    • A

      1.67 V

    • B

      0.17 V

    • 0.83 V

    • D

      8.3 V

    V. A half-wave rectifier would give 1.67 V.

  9. 9

    For a buck converter with V producing 5 V (ideal, continuous mode), the duty cycle is

    • A

      about 0.58

    • B

      about 2.4

    • C

      about 0.71

    • about 0.42

    Vout = D Vin, so D = 5/12 = 0.417. For a boost converter the relation would be Vout = Vin/(1-D).

  10. 10

    An NMOS has V_th = 1 V. With V_GS = 3 V, in which region is it when V_DS = 1 V?

    • Triode

    • B

      Saturation

    • C

      Cutoff

    • D

      Breakdown

    The saturation boundary is V_GS - V_th = 2 V. V_DS = 1 V is below that, so the channel is not pinched off: triode.

  11. 11

    An 8-bit ADC with a 3.3 V reference measures an input. The code is 128. The input voltage is about

    • A

      0.41 V

    • 1.65 V

    • C

      3.3 V

    • D

      0.83 V

    V (about half scale). One LSB is 12.9 mV.

  12. 12

    An inverting amplifier with kΩ, kΩ has an input source with series resistance . The actual gain is about

    • A

      -10

    • B

      -40

    • -8

    • D

      -10.5

    The source resistance adds to : . This is a common loading trap for inverting amplifiers.

  13. 13

    A Schmitt trigger is used instead of a plain comparator mainly to

    • A

      increase the voltage gain

    • B

      reduce power consumption

    • C

      convert current to voltage

    • avoid output chatter from noise on a slowly changing input

    Hysteresis from positive feedback gives separate rising and falling thresholds, so small noise cannot toggle the output repeatedly.

  14. 14

    A 2nd-order Butterworth low-pass filter attenuates by about how much one decade above the cutoff?

    • About 40 dB

    • B

      About 20 dB

    • C

      About 60 dB

    • D

      About 3 dB

    Roll-off is 20n dB/decade; n = 2 gives 40 dB/decade (the first -3 dB is at the cutoff itself).